Saltar navegación principal
Normas SAE – AENOR
SAE J2180_201105

SAE J2180_201105

A Tilt Table Procedure for Measuring the Static Rollover Threshold for Heavy Trucks

* Aviso PDF Secure:

El documento PDF de las normas SAE descargado quedará bloqueado y no podrá traspasarse a otro ordenador, es monopuesto y monousuario.

El usuario final debe tener instalado el sistema de seguridad FILE OPEN PLUG-IN. El documento puede imprimirse una vez.

Fecha publicación:
2011-05-17 /Stabilized
Abstract:
The test procedure applies to roll coupled units such as straight trucks, tractor semitrailers, full trailers, B-trains, etc. The test is aimed at evaluating the level of lateral acceleration required to rollover a vehicle or a roll-coupled unit of a vehicle in a steady turning situation. Transient, vibratory, or dynamic rollover situations are not simulated by this test. Furthermore, the accuracy of the test decreases as the tilt angle increases, although this is a small effect at the levels of tilt angle used in testing heavy trucks. The test accuracy is accepted for vehicles that will rollover at lateral acceleration levels below 0.5 g corresponding to a tilt table angle of less than approximately 27 degrees. Even so, the results for heavy trucks with rollover thresholds greater than 0.5 g could be used for comparing their relative static roll stability.
70,79
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta