Saltar navegación principal
Normas DIN – AENOR
DIN EN 17176-2:2019-07

DIN EN 17176-2:2019-07

Plastics piping systems for water supply and for buried and above ground drainage, sewerage and irrigation under pressure - Oriented unplasticized poly(vinyl chloride) (PVC-O) - Part 2: Pipes; German version EN 17176-2:2019 / Note: This standard is part of the DVGW body of rules.

Systèmes de canalisations en plastique pour l'alimentation en eau, les branchements et collecteurs d'assainissement et les systèmes d'irrigation sous pression, enterrés ou aériens - Poly(chlorure de vinyle) non plastifié orienté (PVC-O) - Partie 2: Tubes; Version allemande EN 17176-2:2019 / Attention: Cette norme fait partie du corpus de règles DVGW.

Kunststoff-Rohrleitungssysteme für die Wasserversorgung und für erdverlegte und nicht erdverlegte Entwässerungs-, Abwasser- und Bewässerungsdruckleitungen - Orientiertes weichmacherfreies Polyvinylchlorid (PVC-O) - Teil 2: Rohre; Deutsche Fassung EN 17176-2:2019 / Achtung: Diese Norm ist Bestandteil des DVGW Regelwerks.

Fecha:
2019-07 /Active
Equivalencias internacionales:

EN 17176-2 (2019-04)

Relación con otras normas DIN:

Reemplaza a: DIN EN 17176-2:2017-11

Resumen:
This document specifies the characteristics of solid-wall pipes made from oriented unplasticized poly(vinyl chloride) (PVC-O) for piping systems intended for water supply and for buried and above-ground drainage, sewerage, irrigation and conveyance of treated waste water under pressure. It also specifies the test parameters for the test methods referred to in this document. In conjunction with DIN EN 17176-1 and DIN EN 17176-5, it is applicable to oriented PVC O pipes without a socket and pipes with a socket (integral or not), intended to be used for the following: a) water mains and service lines; b) conveyance of water for both outside and inside buildings; c) drainage, sewerage and conveyance of treated waste water under pressure; d) irrigation under pressure. It is applicable to piping systems intended for the supply of water with a maximum allowable operating pressure (PFA) up to and including 25 bar. The piping system according to this document is intended for the conveyance of cold water up to and including 45 °C and especially in those applications where special performance requirements are needed, such as impact loads and pressure fluctuations. This document specifies a range of pipe sizes and pressure classes and gives requirements concerning colours.
Keywords:
Drainage, Geometrical properties, Irrigation, Marking, Materials, Mechanical properties, Mouldings (shaped section), Oriented unplasticized polyvinyl chloride, Pipelines, Piping system, Plastic pipelines, Plastic pipes, Plastics, Polyvinyl chloride, Pressure pipes, Properties, PVC-O, PVC-pipes, Sewage, Sewage pipelines, Sewers, Underground, Unplasticized polyvinyl chloride, Water pipes, Water practice, Water supply
83,93
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta