Saltar navegación principal
Normas DIN – AENOR
DIN ISO 12219-1:2010-12

DIN ISO 12219-1:2010-12

Indoor air of road vehicles - Part 1: Whole vehicle test chamber - Specification and method for the determination of volatile organic compounds in cabin interiors (ISO/DIS 12219-1:2010) / Note: Date of issue 2011-01-17

Air intérieur des véhicules routiers - Partie 1: Enceinte d'essai d'un véhicule complet - Spécification et méthode de détermination des composés organiques volatils dans les habitacles de voitures (ISO/DIS 12219-1:2010) / Attention: Date de parution 2011-01-17

Innenraumluft von Straßenfahrzeugen - Teil 1: Gesamtfahrzeugprüfkammer - Spezifikation und Verfahren zur Bestimmung von flüchtigen organischen Verbindungen in der Fahrgastzelle (ISO/DIS 12219-1:2010) / Achtung: Erscheinungsdatum 2011-01-17

Fecha Anulación:
2013-12 /Withdrawn
Equivalencias internacionales:

ISO/DIS 12219-1 (2010-10)

Relación con otras normas DIN:

Reemplazada por: DIN ISO 12219-1:2013-12

Resumen:
This part of ISO 12219 describes and specifies the whole vehicle test chamber, the vapour sampling assembly and the operating conditions each for the determination of volatile organic compounds (VOCs), and carbonyls in vehicle cabin air. There are three measurements performed; one (for VOCs and carbonyls) during the simulation of ambient conditions (ambient mode) at standard conditions of 23 °C with no air exchange, a second only for the measurement of formaldehyde at elevated temperatures (parking mode), and a third for VOCs and carbonyls simulating driving after the vehicle has been parked in the sun starting at elevated temperatures (driving mode). For the simulation of the mean sun irradiation in Europe, Asia, North-America etc. a fixed irradiation in the whole vehicle test chamber is employed. The VOC method is valid for measurement of non-polar and slightly polar VOCs in a concentration range of sub-µg/m<(hoch)3> up to several mg/m<(hoch)3>. The sampling and analysis procedure for formaldehyde and other carbonyl compounds is performed by collecting air onto cartridges coated with 2,4-dinitrophenylhydrazine (DNPH) and subsequent analysis by high performance liquid chromatography (HPLC) with detection by ultraviolet absorption. Formaldehyde and other carbonyl compounds can be determined in the concentration range of approximately 1 µg/m<(hoch)3> to 1 mg/m<(hoch)3>. The method is valid for new and used passenger cars. This part of ISO 12219 describes: - transport and storage of the test vehicles until the start of the test, - conditioning for the surroundings of the test vehicle and the test vehicle itself as well as the whole vehicle test chamber, - conditioning of the test vehicle prior to measurements, - simulation of ambient air conditions (ambient mode), - formaldehyde sampling at elevated temperatures (parking mode), - simulation of driving after the test vehicle has been parked in the sun (driving mode).
Keywords:
Air quality, Cabins, Carbonyl content, Definitions, Driver's cabins, Formaldehyde concentration, Health protection, Indoors, Inner atmosphere, Liquid chromatography, Measuring techniques, Motorcar industry, Pollution of the air, Quality assurance, Road vehicles, Specimen preparation, Test chamber, Testing, Vehicles, VOC, Volatile organic compounds
82,24
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta