Saltar navegación principal
Normas DIN – AENOR
DIN 6935:2010-09

DIN 6935:2010-09

Cold bending of flat rolled steel / Note: Date of issue 2010-09-06

Cintrage à froid des produits plats en acier / Attention: Date de parution 2010-09-06

Kaltbiegen von Flacherzeugnissen aus Stahl / Achtung: Erscheinungsdatum 2010-09-06

Fecha Anulación:
2011-10 /Withdrawn
Relación con otras normas DIN:

Reemplazada por: DIN 6935:2011-10

Resumen:
This standard applies to bent components made from flat steel products for application in steel construction and general mechanical engineering. When bending flat rolled steel, such as sheets and plates, strips, wide flats etc., the rolling in direction should be considered, since bending should if possible be carried out transverse to the rolling direction owing to the greater suitability to bending offered. The bending suitability of the rolled steel shall be agreed with the manufacturer's works when ordering.
Keywords:
Angle of bend, Aperture angles, Bending, Bending characteristics, Cold-bending, Compensation values, Correction factors, Developments, Dimensions, Elastic lines, Flat rolled products, Linear dimensions, Materials, Mechanical engineering, Rolled, Sheet materials, Steels, Stretched, Strips, Structural steel work, Sweeps, Tolerances (measurement), Wide flats
47,01
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta