Saltar navegación principal
Normas DIN – AENOR
DIN EN ISO 8062-3:2008-09

DIN EN ISO 8062-3:2008-09

Geometrical Product Specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 3: General dimensional and geometrical tolerances and machining allowances for castings (ISO 8062-3:2007); German version EN ISO 8062-3:2007 / Note: To be replaced by DIN EN ISO 8062-3 (2019-08).

Spécification géométrique des produits (GPS) - Tolérances dimensionnelles et géométriques des pièces moulées - Partie 3: Tolérances dimensionnelles et géométriques générales et surépaisseurs d'usinage pour les pièces moulées (ISO 8062-3:2007); Version allemande EN ISO 8062-3:2007 / Attention: À remplacer par DIN EN ISO 8062-3 (2019-08).

Geometrische Produktspezifikationen (GPS) - Maß-, Form- und Lagetoleranzen für Formteile - Teil 3: Allgemeine Maß-, Form- und Lagetoleranzen und Bearbeitungszugaben für Gussstücke (ISO 8062-3:2007); Deutsche Fassung EN ISO 8062-3:2007 / Achtung: Vorgesehener Ersatz durch DIN EN ISO 8062-3 (2019-08).

Fecha:
2018-09 /Active
Equivalencias internacionales:

EN ISO 8062-3 (2007-06)

ISO 8062-3 (2007-06)

Resumen:
This part of ISO 8062 specifies general dimensional and geometrical tolerances, as well as machining allowance grades, for castings as delivered to the purchaser in accordance with ISO 8062-2. It is applicable for the tolerancing of dimensions and geometry of castings in all cast metals and their alloys produced by various casting manufacturing processes. This part of ISO 8062 applies to both general dimensional and general geometrical tolerances (referred to in or near the title block of the drawing), unless otherwise specified, and where specifically referred to on the drawing by one of the references in Clause 9. The dimensional tolerances covered by this part of ISO 8062 are tolerances for linear dimensions. The geometrical tolerances covered by this part of ISO 8062 are: - tolerances for straightness, - flatness, - roundness, - parallelism, - perpendicularity, - symmetry, and coaxiality. This part of ISO 8062 can be used for the selection of tolerance values for individual indications. NOTE This part of ISO 8062 does not apply to 3D CAD models used without indicated dimensions.
Keywords:
Castings, Dimensional tolerances, Dimensions, Finishes, Form tolerances, Forming operations, Foundry practice, General tolerances, Geometric, Geometrical product specification, Geometry, GPS, Machining tolerances, Moulded parts, Position, Product specification, Product specifications, Products, Shape, Specification, Surveys, Tolerances (measurement), Tolerances of position, Workpieces
88,32
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta