Saltar navegación principal
Normas DIN – AENOR
DIN EN 1264-2:2009-01

DIN EN 1264-2:2009-01

Water based surface embedded heating and cooling systems - Part 2: Floor heating: Prove methods for the determination of the thermal output using calculation and test methods; German version EN 1264-2:2008

Systèmes de surfaces chauffantes et rafraîchissantes hydrauliques intégrées - Partie 2: Chauffage par le sol: Méthodes de démonstration pour la détermination de l'émission thermique utilisant des méthodes par le calcul et à l'aide de méthodes d'essai; Version allemande EN 1264-2:2008

Raumflächenintegrierte Heiz- und Kühlsysteme mit Wasserdurchströmung - Teil 2: Fußbodenheizung: Prüfverfahren für die Bestimmung der Wärmeleistung unter Benutzung von Berechnungsmethoden und experimentellen Methoden; Deutsche Fassung EN 1264-2:2008

Fecha Anulación:
2013-03 /Withdrawn
Equivalencias internacionales:

EN 1264-2 (2008-10)

Relación con otras normas DIN:

Reemplaza a: DIN EN 1264-2:2007-04

Reemplaza a: DIN EN 1264-2:1997-11

Reemplazada por: DIN EN 1264-2:2013-03

Reemplaza a: DIN 4725-200:2001-03

Resumen:
This European Standard specifies the boundary conditions and the prove methods for the determination of the thermal output of hot water floor heating systems as a function of the temperature difference between the heating medium and the room temperature. This standard shall be applied to commercial trade and practical engineering if proved and certifiable values of the thermal output shall be used. This European Standard applies to heating and cooling systems embedded into the enclosure surfaces of the room to be heated or to be cooled. This Part of this European Standard applies to hot water floor heating systems. Applying of Part 5 of this European Standard requires the prior use of this Part of this European Standard. Part 5 of this European Standard deals with the conversion of the thermal output of floor heating systems determined in Part 2 into the thermal output of heating surfaces embedded in walls and ceilings as well as into the thermal output of cooling surfaces embedded in floors, walls and ceilings. The thermal output is proved by a calculation method (Clause 6) and by a test method (Clause 9). The calculation method is applicable to systems corresponding to the definitions in EN 1264-1 (type A, type B, type C, type D). For systems not corresponding to these definitions, the test method shall be used. The calculation method and the test method are consistent with each other and provide correlating and adequate prove results. The prove results, expressed depending on further parameters, are the standard specific thermal output and the associated standard temperature difference between the heating medium and the room temperature as well as fields of characteristic curves showing the relationship between the specific thermal output and the temperature difference between the heating medium and the room.
Keywords:
Ambient temperatures, Approval laboratories, Buildings, Ceilings, Central heating, Cooling systems, Determination, Domestic facilities, Experimental, Heat conduction, Heat engineering, Heat flow, Heat flow density, Heated systems, Heating equipment, Heating installations, Heating technics, Hot-water central heating, Influence factors, Mathematical calculations, Methods of calculation, Office buildings, Pipe laying, Ratings, Screeds (floors), Systems, Testing, Thermal conductivity, Thermal efficiency, Thermal environment systems, Thermal output, Thermal resistance, Underfloor heating, Walls, Warm water
104,58
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta