Saltar navegación principal
Normas BSI – AENOR
BS ISO 7902-1:2020

BS ISO 7902-1:2020

Hydrodynamic plain journal bearings under steady-state conditions. Circular cylindrical bearings. Calculation procedure

Fecha:
2020-08-03 /Definitive
Comité:
MCE/12
Equivalencias internacionales:

ISO 7902-1

Relación con otras normas BSI:

Reemplaza a: BS ISO 7902-1:2013

Resumen:

This document specifies a calculation procedure for oil-lubricated hydrodynamic plain bearings, with complete separation of the shaft and bearing sliding surfaces by a film of lubricant, used for designing plain bearings that are reliable in operation.

It deals with circular cylindrical bearings having angular spans, ?, of 360°, 180°, 150°, 120°, and 90°, the arc segment being loaded centrally. Their clearance geometry is constant except for negligible deformations resulting from lubricant film pressure and temperature.

The calculation procedure serves to provide dimensions and optimize plain bearings in turbines, generators, electric motors, gear units, rolling mills, pumps, and other machines. It is limited to steady-state operation, i.e. under continuously driven operating conditions, with the magnitude and direction of loading as well as the angular speeds of all rotating parts constant. It can also be applied if a full plain bearing is subjected to a constant force rotating at any speed. Dynamic loadings (i.e. those whose magnitude and direction vary with time), such as those that can result from vibration effects and instabilities of rapid-running rotors, are not taken into account.

NOTE

Equivalent calculation procedures exist that enable operating conditions to be estimated and checked against acceptable conditions. The use of them is equally admissible.

Keywords:
Bearings, Loading, Axial-thrust bearings, Friction, Load capacity, Plain bearings, Lubricants, Mathematical calculations, Hydrodynamics
235,9
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta