Saltar navegación principal
Normas BSI – AENOR
BS EN 14064-1:2018

BS EN 14064-1:2018

Thermal insulation products for buildings. In-situ formed loose-fill mineral wool (MW) products. Specification for the loose-fill products before installation

Fecha:
2018-11-09 /Under Review
Comité:
PRI/72
Equivalencias internacionales:

EN 14064-1:2018

Relación con otras normas BSI:

Reemplaza a: BS EN 14064-1:2010

Resumen:
This document specifies the requirements for blown and injected loose-fill mineral wool products for in situ installation in lofts, masonry cavity walls and frame constructions. This document is a specification for the insulation products before installation. It describes the product characteristics and includes procedures for testing, marking and labelling. This document does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards. NOTE To avoid water penetration in masonry walls special tests adjusted to local climate might be needed. This document does not cover factory made mineral wool (MW) insulation products or in situ products intended to be used for the insulation of building equipment and industrial installations. Products with a declared thermal resistance lower than 0,25 m2·K/W or a declared thermal conductivity greater than 0,060 W/(m·K) at 10 °C are not covered by this document. This document does not cover products intended for airborne sound insulation and for acoustic absorption applications.
Keywords:
Designations, Thermal insulating materials, Thermal insulation, Mineral wool, Conformity, Thermal testing, Thermal resistance, Cavity walls, Marking, Fibres, Quality control, Thermal conductivity, Roof spaces, Buildings, In-situ construction, Construction materials
302,1
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta