Saltar navegación principal
Normas BSI – AENOR
BS EN 50539-11:2013+A1:2014

BS EN 50539-11:2013+A1:2014

Low-voltage surge protective devices. Surge protective devices for specific application including d.c.. Requirements and tests for SPDs in photovoltaic applications

Fecha Anulación:
2019-12-03 /Withdrawn
Comité:
PEL/37/1
Equivalencias internacionales:

EN 50539-11:2013/A1:2014

Relación con otras normas BSI:

Reemplazada por: BS EN 61643-31:2019

Resumen:

This European Standard defines the requirements and tests for SPDs intended to be installed on the d.c. side of photovoltaic installations to protect against induced and direct lightning effects. These devices are connected to d.c. power circuits of photovoltaic generators, rated up to 1 500 V.

It takes into account that photovoltaic generators:

  • behave like current generators,

  • that their nominal current depends on the light intensity,

  • that their short-circuit current is almost equal to the nominal current,

  • are connected in series and/or parallel combinations leading to a great variety of voltages, currents and powers from a few hundreds of W (in residential installations) to several MW (photovoltaic fields).

The very specific electrical parameters of PV installations on the d.c. side require specific test requirements for SPDs.

SPDs with separate input and output terminal(s) that contain a specific series impedance between these terminal(s) (so called two port SPDs according to EN 61643-11 ) are currently not sufficiently covered by the requirements of this standard and require additional consideration.

NOTE

In general SPDs for PV applications do not contain a specific series impedance between the input/output terminals due to power efficiency considerations.

SPDs complying with this standard are exclusively dedicated to be installed on the d.c. side of photovoltaic generators. PV installation including batteries and other d.c. applications are not taken into account and additional requirements and tests may be necessary for such applications.

SPDs for which the manufacturers declares short circuit mode overload behaviour, shall require specific measures to ensure that such devices will not endanger the operator during maintenance and replacement due to possible d.c. arcing.

Keywords:
Codes, Electrical components, Environment (working), Electronic equipment and components, Classification systems, Testing conditions, Environmental testing, Electrical equipment, Test specimens
281,37
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta