Saltar navegación principal
Normas BSI – AENOR
BS EN 124-2:2015

BS EN 124-2:2015

Gully tops and manhole tops for vehicular and pedestrian areas. Gully tops and manhole tops made of cast iron

2015-07-31 /Under Review
Equivalencias internacionales:

EN 124-2:2015


This European Standard is applicable to gully tops and manhole tops made of flake graphite cast iron and/or spheroidal graphite cast iron whether in combination with concrete or not, with a clear opening up to and including 1 000 mm for covering gullies, manholes and inspection chambers for installation within areas subjected to pedestrian and/or vehicular traffic.

It is applicable to manhole tops and gully tops for use in

  • areas which can only be used by pedestrians and pedal cyclists (at least class A 15),

  • pedestrian areas and comparable areas, car parks or car parking decks (at least class B 125),

  • the area of kerbside channels of roads which, when measured from the kerb edge, extends a maximum of 0,5 m into the carriageway and a maximum of 0,2 m into the pedestrian area (at least class C 250),

  • carriageways of roads (including pedestrian streets), hard shoulders and parking areas, for all types of road vehicles (at least class D 400),

  • areas imposing high wheel loads, e.g. docks, aircraft pavements (at least class E 600),

  • areas imposing particularly high wheel loads, e.g. aircraft pavements (class F 900).

This European Standard is not applicable in isolation but only in combination with EN 124-1 and gives guidance for combinations of covers/grating made of cast iron with frames according to EN 124-3 , EN 124-4 , EN 124-5 or EN 124-6 .

This European Standard is not applicable to:

  • cover fillings installed on site, e.g. concrete, paving blocks, etc.;

  • concave gratings for class D 400 installed in carriageways of roads or hard shoulders and concave gratings for classes F 900 and E 600;

  • gratings/covers as part of prefabricated drainage channels according to EN 1433 ;

  • floor and roof gullies in buildings which are specified in EN 1253 (all parts); and

  • surface boxes.

Grades (quality), Surface-water drainage, Roads, Statistical quality control, Concretes, Rainwater control systems, Test specimens, Slots, Construction systems parts, Quality assurance, Gullies, Position, Cast steels, Loading, Certification (approval), Quality control, Design, Inspection, Manholes, Reinforced concrete, Cast-iron, Dimensions, Type testing, Drainage, Deflection tests, Marking
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta