Saltar navegación principal
Normas BSI – AENOR
BS EN 74-2:2008

BS EN 74-2:2008

Couplers, spigot pins and baseplates for use in falsework and scaffolds. Special couplers. Requirements and test procedures

Fecha:
2010-06-30 /Revision Underway
Comité:
B/514
Equivalencias internacionales:

EN 74-2:2008

Resumen:
EN 74 2 specifies: - materials; - design requirements; - specified values for resistances and stiffnesses which a coupler has to achieve under test; - test procedures and assessment; for the following special couplers: - screw or wedge half couplers, sleeve couplers with shear studs, right angle reduction couplers and swivel reduction couplers. It gives recommendations for on going production control. These couplers are for use principally in temporary works. Each coupler is able to be fixed to at least one side to one 48,3 mm diameter steel or aluminium tube. For the other side of reduction couplers, this standard defines requirements for the diameter and wall thickness of tubes. For testing, screw couplers are tightened with a torque of 50 Nm and wedge couplers are tightened with a 500 g hammer until the jarring blow. Other special half couplers such as half couplers attached by riveting, used mainly for members of prefabricated scaffolds, are outside the scope of this European Standard. NOTE Some information on design using special couplers is given in Annex B.
Keywords:
Construction equipment, Aluminium, Couplers (scaffolding), Mechanical testing, Bend testing, Scaffolds, Classification systems, Quality control, Temporary structures, Inspection, Scaffolding components, Falsework, Failure (mechanical), Steels, Slip, Strength of materials, Designations, Force measurement, Load capacity, Scaffolding fixing components, Design
240,25
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta