Saltar navegación principal
Normas BSI – AENOR
BS EN IEC 60730-2-14:2019

BS EN IEC 60730-2-14:2019

Automatic electrical controls. Particular requirements for electric actuators

2019-02-27 /Revision Underway
Equivalencias internacionales:

EN IEC 60730-2-14:2019

EN 61784-3-8:2010

IEC 60730-2-14:2017

Relación con otras normas BSI:

This clause of Part 1 is applicable except as follows:

1.1 Replacement:

This part 2-14 applies to electric actuators for use in, on, or in association with equipment for household and similar use. The equipment may use electricity, gas, oil, solid fuel, solar thermal energy, etc., or a combination thereof.


Throughout this standard the word "equipment" means "appliance and equipment."


Electric actuators for appliances within the scope of IEC 60335 .

This International Standard is applicable to controls for building automation within the scope of ISO 16484 .

This part 2-14 also applies to automatic electrical controls for equipment that may be used by the public, such as equipment intended to be used in shops, offices, hospitals, farms and commercial and industrial applications.


Controls for commercial catering, heating and air-conditioning equipment.

This part 2-14 is also applicable to individual electric actuators utilized as part of a control system or controls, which are mechanically integral with multifunctional controls having non-electrical outputs.


Independently mounted water valves, controls in smart grid systems and controls for building automation systems within the scope of ISO 16484-2 .

This part 2-14 does not apply to automatic electric actuators intended exclusively for industrial process applications unless explicitly mentioned in the relevant part 2 or the equipment standard.

1.1.1 This part 2-14 applies to the inherent safety, to the operating values, operating times and operating sequences where such are associated with equipment safety and to the testing of electric actuators used in or in association with equipment.


Requirements for specific operating values, operating times and operating sequences may be given in the standards for appliances and equipment.

This standard is also applicable to the functional safety of low complexity safety related systems and controls.

This part 2-14 does not apply to electric actuators which are mechanically integrated with valves covered by a separate part 2, e.g. IEC 60730-2-8 .

This part 2-14 does not apply to electric motors, requirements for which are contained in IEC 60034 .

1.1.2 Requirements for manual switches not integral with an electric actuator are contained in IEC 61058-1 .

1.1.3 Replacement

This part 2-14 applies to a.c. or d.c. powered electric actuators with a rated voltage not exceeding 690 V a.c. or 600 V d.c.

1.1.4 Replacement

This part 2-14 does not take into account the response value of an automatic action of an electric actuator, if such a response value is dependent upon the method of mounting the electric actuator in the equipment. Where a response value is of significant purpose for the protection of the user, or surroundings, the value defined in the appropriate household equipment or as determined by the manufacturer shall apply.

Thermal testing, Radio disturbances, Control devices, Safety engineering, Strength of materials, Domestic, Clearances, Classification systems, Equipment safety, Conformity, Thermistors, Ratings, Assembling, Corrosion resistance, Instructions for use, Electric actuators, Performance testing, Heating, Electrical household appliances, Household equipment, Controllers, Testing conditions, Electric control equipment, Leakage paths, Endurance testing, Control equipment, Type testing, Actuators, Automatic control systems
Idioma Formato

Formato digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta