Saltar navegación principal
Normas ASTM – AENOR
ASTM D3183-10(2019)

ASTM D3183-10(2019)

Standard Practice for Rubber—Preparation of Pieces for Test Purposes from Products

Fecha:
2019-12-17 /Active
Significance and Use:

4.1 This practice is used when it is necessary to test a product from which specimens cannot be cut directly. Procedures are given for preparing pieces suitable for preparing specimens of the product.

Scope:

1.1 This practice covers methods for the preparation of pieces of a rubber vulcanizate that is not in the form of sheet. Such pieces are used as a source from which specimens are obtained for testing.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords:
cutting; Emerson Type rubber buffer; rubber buffer; rubber buffing; skiving; test piece; test piece preparation; test specimen; testing of finished products;
38,23
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta