Saltar navegación principal
Normas ASTM – AENOR
ASTM B26/B26M-18e1

ASTM B26/B26M-18e1

Standard Specification for Aluminum-Alloy Sand Castings

Fecha:
2018-08-03 /Active
Abstract:

This specification covers aluminum alloy sand castings except those that are for aerospace applications. The chemical compositions are determined in accordance with the specified suitable chemical and spectrochemical test methods. Addition of small amounts of modifiers and grain refining elements to the molten alloys from the remelting furnace is permitted before casting. Pure metals, recycled materials, and master alloys can also be used to make the alloys as long as the chemical composition can be analyzed and adjusted to conform to the requirements prior to pouring any casting. Castings should only be repaired using approved processes such as welding, impregnation, peening, blending, soldering, and so forth.

Scope:

1.1 This specification2 covers aluminum-alloy sand castings designated as shown in Table 1.

1.2 This specification is for aluminum-alloy sand castings used in general purpose applications. It may not address the mechanical properties, integrity testing, and verification required for highly loaded or safety critical applications.

1.3 Alloy and temper designations are in accordance with ANSI H35.1/H35.1M.

1.4 Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units.

1.5 For acceptance criteria for inclusion of new aluminum and aluminum alloys and their properties in this specification, see Annex A1 and Annex A2.

1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords:
aluminum; sand casting;
47,2
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta