Saltar navegación principal
Normas ASTM – AENOR
ASTM D4333/D4333M-18

ASTM D4333/D4333M-18

Standard Practice for Compatibility of Mechanical Pump Dispenser Components

Fecha:
2018-07-19 /Active
Significance and Use:

2.1 This practice identifies the compatibility of the mechanical pump dispenser components with consumer-type products.

Scope:

1.1 This practice covers testing of the components of mechanical pump dispensers (spray or flow types) for compatibility with products.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords:
chemical resistance; compatibility; mechanical pump dispenser components;
37,95
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta