Saltar navegación principal
Normas ASTM – AENOR
ASTM E1109-18

ASTM E1109-18

Standard Test Method for Determining the Bulk Density of Solid Waste Fractions

Fecha:
2019-02-20 /Historical
Superseeded by:
Significance and Use:

5.1 This test method describes a physical property of solid waste in processing facilities, a property that characterizes the solid waste streams and hence the operation of resource recovery separators and processors.

5.2 The bulk density is an important property for the design of materials handling equipment, separators, and processors.

Scope:

1.1 This test method may be used to determine the bulk density of various fractions from the resource recovery processing of municipal solid waste. It is intended as a means of characterizing such fractions and for providing data useful to designers of solid waste processing plants.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

44,42
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta