Saltar navegación principal
Normas ASTM – AENOR
ASTM D968-17

ASTM D968-17

Standard Test Methods for Abrasion Resistance of Organic Coatings by Falling Abrasive

Fecha:
2017-06-19 /Active
Significance and Use:

5.1 Silica sand produces a slower rate of abrasion for organic coatings than that provided by silicon carbide. For some types of coatings, it may also provide greater differentiation.

5.2 The abrasion resistance scales produced by the two methods differ, but the methods provide approximately the same rankings of coatings for abrasion resistance.

5.3 Each of the methods has been found useful for rating the abrasion resistance of specific types of coatings. For example Method A (falling sand) has been used for rating floor coatings while Method B (falling silicon carbide) has been used for rating coatings for ship decks.

FIG. 1 Apparatus for Falling Sand Abrasion Test

Apparatus for Falling Sand Abrasion Test

FIG. 2 Design Details of Abrasion Test Apparatus

Design Details of Abrasion Test ApparatusDesign Details of Abrasion Test Apparatus

Note 1: All dimensions are given in inches. 1 in. = 25.4 mm.

Scope:

1.1 These test methods cover the determination of the resistance of organic coatings to abrasion produced by abrasive falling onto coatings applied to a plane rigid surface, such as a metal or glass panel.

1.2 Two test methods based on different abrasives are covered as follows:

 

Sections

Method A—Falling Sand Abrasion Test

6 – 13

Method B—Falling Silicon Carbide Abrasion Test

14 – 21

1.3 These methods should be restricted to testing in only one laboratory when numerical values are used because of the poor reproducibility of the methods (see 13.1.2 and 21.1.2). Interlaboratory agreement is improved significantly when ranking is used in place of numerical values.

1.4 The values stated in SI units are to be regarded as the standard with the exception of mils when determining coating thickness. The values given in parentheses are for information only.

1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords:
abrasion; abrasion (of paints/related coatings); falling abrasive tester; falling sand abrasion test; falling silicon carbide abrasion test; resistance;
43,1
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta