Saltar navegación principal
Normas ASTM – AENOR
ASTM D3794-16

ASTM D3794-16

Standard Guide for Testing Coil Coatings

Fecha:
2017-02-28 /Historical
Superseeded by:
Significance and Use:

4.1 This guide represents a collection of pertinent ASTM test methods used within the coil coatings industry. In the past coil coaters world wide depended on industry standards written by the National Coil Coaters Association. That association, working cooperatively with ASTM, will no longer issue new, nor update old, standards.

Scope:

1.1 This guide covers procedures for testing coil coatings. The test methods included are listed in Table 1. Where more than one test method is listed for the same characteristic, no attempt is made to indicate superiority of one method over another. Selection of test methods to be followed must be governed by the requirements in each individual case, together with agreement between the producer and user.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 7 on Hazards.

Keywords:
absorbance; accelerated; acetic acid; adhesion; chip resistance; chromate; coil coatings; color; cone and plate; cyclic; density; dew cycle; film thickness; fame spread; fluorescent-UV condensation; Fresnel; glass transition; hardness; humidity; impact; irradiance; Kesternich; metamerism; methods; pH; phosphate; reflectance; salt spray; solar reflectance; solids; solvent resistance; standards; Taber; T bends; transmittance; viscosity; VOC; weathering; xenon; Zahn;
57,27
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta