Saltar navegación principal
Normas ASTM – AENOR
ASTM B434-06(2016)

ASTM B434-06(2016)

Standard Specification for Nickel-Molybdenum-Chromium-Iron Alloys (UNS N10003, UNS N10242) Plate, Sheet, and Strip

Fecha:
2016-12-27 /Active
Abstract:

This specification covers nickel-molybdenumchromium-iron alloys (UNS N10003 and UNSN10242) plate, sheet, and strip for use in general corrosive service. Alloys in the form of sheet, strips, and plates may be hot or cold rolled, annealed, and descaled. Physical properties like grain size, weight, thickness, width, length, straightness, squareness, flatness, and edges of the specimens shall be determined. Plate and sheet mechanical properties like tensile strength, yield strength, and elongation shall be measured.

Scope:

1.1 This specification2 covers nickel-molybdenum-chromium-iron alloys (UNS N10003 and UNS N10242)3 plate, sheet, and strip for use in general corrosive service.

1.2 The following products are covered under this specification:

1.2.1 Sheet and Strip—Hot or cold rolled, annealed, and descaled unless annealing is performed in an atmosphere yielding a bright finish.

1.2.2 Plate—Hot rolled, annealed, and descaled.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

Keywords:
plate; sheet; strip; UNS N10003 ; UNS N10242;
38,64
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta