Saltar navegación principal
ASTM D4873-15

ASTM D4873-15

Standard Guide for Identification, Storage, and Handling of Geosynthetic Rolls and Samples

2016-01-14 /Historical
Superseeded by:
Significance and Use:

4.1 For a geosynthetic to be properly used it must be adequately identified and packaged. It must be handled and stored in such a way that its physical property values are not degraded. Failure to follow good practice may result in the unnecessary failure of the geosynthetic in a properly designed application.

4.2 This guide is not intended to replace project-specific storage, handling, identification, packaging, or installation requirements or quality assurance programs.


1.1 This guide provides guidelines for the identification and packaging of rolled geosynthetics by the manufacturer and for the handling and storage of geosynthetics by the end user. This guide is not to be considered as all encompassing since each project involving geosynthetics presents its own challenges and special conditions. Geosynthetic samples are often taken at manufacturer, supplier, or at the job site primarily for the purpose of conformance testing and verification. These samples should be properly labeled for identification purposes.

1.2 This guide is intended to aid manufacturers, suppliers, purchasers, and users of geosynthetics for identification, handling, and storage.

1.3 This guide is not applicable for factory fabricated panels due to a different set of identifications for the panel by the fabricator. For Fabricated Geomembrane Panels, refer to Guide D7865.

1.4 This guide is not intended for Geosynthetic Clay Liners. For GCL’s, refer to Guide D5888.

1.5 This guide is also applicable to geosynthetic samples.

1.6 Each type of Geosynthetic is listed by section to address specific requirements.


Geotextiles – Section 5


Geogrids – Section 6


Geomembrane Rolls – Section 7


Geonets – Section 8


Geocomposites – Section 9

1.7 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

geosynthetics; identification; labeling; quality assurance; storage;
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta