Saltar navegación principal
ASTM F2321-14

ASTM F2321-14

Standard Specification for Flexible and Rigid Insulated Temporary By-Pass Jumpers

2020-03-05 /Historical
Superseeded by:

1.1 These specifications cover the manufacture and testing of flexible insulated temporary By-Pass jumpers (By-Pass jumpers) used on energized power lines and equipment.

1.2 It is common practice for the user of this protective equipment to prepare complete instructions and safety regulations to govern in detail the correct and safe use of such equipment. Also see 4.2.

1.3 The use and maintenance of this equipment are beyond the scope of these specifications.

1.4 These specifications for a system of By-Pass jumpers is covered in four parts as follows:



Clamps for By-Pass Jumpers

5 – 17

Ferrules for By-Pass Jumpers

18 – 31

Cable for By-Pass Jumpers

32 – 40

By-Pass Jumpers (complete assembly
 with clamps, ferrules, and cable)

41 – 55

1.5 Each of the four parts is an entity of itself, but is listed as a part of the system for completeness and clarification.

1.6 The values stated in SI units are to be regarded as the standard. See IEEE/ASTM SI 10.

1.7 The following precautionary caveat pertains only to the test method portions, Sections 13, 26, 48, and 55 of these specifications. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

By-Pass jumpers; lineman; lineman protective equipment
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta