Saltar navegación principal
Normas ASTM – AENOR
ASTM E2275-14

ASTM E2275-14

Standard Practice for Evaluating Water-Miscible Metalworking Fluid Bioresistance and Antimicrobial Pesticide Performance

Fecha:
2019-11-12 /Historical
Superseeded by:
Significance and Use:

5.1 This practice provides laboratory procedures for rating the relative bioresistance of metalworking fluid formulations, for determining the need for microbicide addition prior to or during fluid use in metalworking systems and for evaluating microbicide performance. General considerations for microbicide selection are provided in Practice E2169.

5.2 The factors affecting challenge population numbers, taxonomic diversity, physiological state, inoculation frequency and biodeterioration effects in recirculating metalworking fluid systems are varied and only partially understood. Consequently, the results of tests completed in accordance with this practice should be used only to compare the relative performance of products or microbicide treatments included in a test series. Results should not be construed as predicting actual field performance.

Scope:

1.1 This practice addresses the evaluation of the relative inherent bioresistance of water-miscible metalworking fluids, the bioresistance attributable to augmentation with antimicrobial pesticides or both. It replaces Methods D3946 and E686.

1.2 In this practice relative bioresistance is determined by challenging metalworking fluids with a biological inoculum that may either be characterized (comprised of one or more known biological cultures) or uncharacterized (comprised of biologically contaminated metalworking fluid or one or more unidentified isolates from deteriorated metalworking fluid). Challenged fluid bioresistance is defined in terms of resistance to biomass increase, viable cell recovery increase, chemical property change, physical property change or some combination thereof.

1.3 This practice is applicable to antimicrobial agents that are incorporated into either the metalworking fluid concentrate or end-use dilution. It is also applicable to metalworking fluids that are formulated using non-microbicidal, inherently bioresistant components.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords:
antimicrobial; bacteria; bactericide; biocide; bioresistant; coolant; fungi; fungicide; metalworking fluid; microbicide; mold; pesticide; yeast
51,52
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta