Saltar navegación principal
Normas ASTM – AENOR
ASTM D1636-13

ASTM D1636-13

Standard Specification for Allyl Molding Compounds

Fecha:
2016-12-27 /Active
Abstract:

This specification provides for the identification of three types of allyl molding compounds, based on the general type of filler employed in their manufacture: Type I - High-strength materials, glass-fiber reinforced; Type II - General-purpose mineral filled; and Type III - General-purpose synthetic fiber filler. Types I and II may be subdivided into four classes according to resin composition and use as follows: Class A - Diallyl ortho-phthalate resin, nonflame-retardant; Class B - Diallyl ortho-phthalate resin, flame-retardant; Class C - Diallyl meta-phthalate resin nonflame-retardant; and Class D - Diallyl meta-phthalate resin, flame-retardant. Materials shall be compression molded, conditioned, and tested; and the individual grades shall conform to specified values of impact resistance, flexural strength, permittivity and dissipation factor, insulation resistance, flame resistance, and oxygen index.

Scope:

1.1 This specification covers compression molding, thermosetting, allyl compounds as further defined in Section 3.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1The properties included in this specification are those required to identify the molding compounds covered. There may be other requirements necessary to identify particular characteristics. These will be added to the specification as their inclusion becomes generally desirable and the necessary test data and methods become available.
Note 2There is no known ISO equivalent to this standard.
Keywords:
allyl; diallyl phthalate (DAP); molding compounds-thermosetting
37,26
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta