Saltar navegación principal
Normas ASTM – AENOR
ASTM F467-13

ASTM F467-13

Standard Specification for Nonferrous Nuts for General Use

Fecha:
2014-02-12 /Historical
Superseeded by:
Abstract:

This specification covers the requirements for commercial wrought nonferrous nuts in nominal thread diameters M6 to M36 inclusive in a number of alloys in common use and intended for general service applications. Materials shall be tested and shall conform to the chemical composition, hardness, proof stress, proof load, and tensile stress requirements.

Significance and Use:

11.1 For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29.

Scope:

1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications.

1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this specification are covered by Specification F468.

1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1This specification is the inch-pound companion to Specification F467M; therefore, no SI equivalents are presented in the specification.
Keywords:
 general use; nonferrous; nuts
51,16
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta