Saltar navegación principal
ASTM D6100-11

ASTM D6100-11

Standard Specification for Extruded, Compression Molded and Injection Molded Polyoxymethylene Shapes (POM)

2014-05-21 /Historical
Superseeded by:

This specification covers the requirements and test methods for the material, dimensions, workmanship, and properties of extruded, compression molded, and injection molded acetal shapes such as sheet, plate, rod, and tubular bar. The specimens shall be a pure polyoxymethylene or may filled, lubricated, or reinforced with carbon and graphite fiber, glass, PTFE, graphite, silicone, molybdenum disulfide, mineral, combinations of reinforcements or fillers, or both. The products shall conform to the physical property requirements which include tensile strength, elongation at break, tensile modulus, dimensional stability, flexural modulus, Izod impact, and porosity level. Thickness tolerance, length camber, and width bow properties shall also comply with the dimensional requirements of the different acetal shapes.


1.1 This specification covers requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded, compression molded and injection molded polyoxymethylene (POM) sheet, plate, rod, and tubular bar shapes, excluding pipe and fittings.

1.2 The properties included in this specification are those required for the compositions covered. Section 4 presents a classification system for defining requirements for particular characteristics important to specialized applications.

1.3 This specification allows for the use of recycled plastics.

1.4 The values stated in inch-pound units are to be regarded as the standard in all property and dimensional tables. For reference purposes, SI units are included in Table S-POM and Table 1 only.

1.5 The following precautionary caveat pertains only to the test method portions, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this standard.

POM; centerline porosity<char: emdash>POM; copolymer<char: emdash>POM; homopolymer<char: emdash>POM; low porosity<char: emdash>POM; plates<char: emdash>POM; porosity level 1<char: emdash>POM; recycled<char: emdash>POM; rod<char: emdash>POM; shapes<char: emdash>POM; sheet<char: emdash>POM; tubular bar<char: emdash>POM; Acetal plastics--specifications; Extrusion compounds (plastic)--specifications; Molding/extrusion compounds/materials--specifications; Polyacetal plastics; Polyoxymethylene (POM)--specifications
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta