Saltar navegación principal
Normas ASTM – AENOR
ASTM D3641-10

ASTM D3641-10

Standard Practice for Injection Molding Test Specimens of Thermoplastic Molding and Extrusion Materials

Fecha:
2010-12-31 /Historical
Superseeded by:
Significance and Use:

It is well known that plastic test specimens molded under different conditions can have significantly different properties. This practice is designed to minimize those differences by establishing operating protocols without being unnecessarily restrictive.

Always refer to the ASTM material specification or ISO designation for the material for recommended molding conditions. If not available, consult the material supplier.

This practice requires the use of adequate quantities of plastic material to find desirable operating conditions and to make the desired test specimens.

Scope:

1.1 This practice covers the general principles to be followed when injection molding test specimens of thermoplastic molding and extrusion materials. This practice is to be used to obtain uniformity in methods of describing the various steps of the injection molding process and to set up uniform methods of reporting these conditions. The exact conditions required to prepare suitable specimens will vary for each plastic material. Those conditions should become a part of the specification for the material, or be agreed upon between the purchaser and the supplier. Any requirements or recommendations in the material specification which differ from this standard take precedence over those in this standard.

1.2 The methodology presented assumes the use of reciprocating screw injection molding machines.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—This practice is equivalent to the following parts of ISO 294: PlasticsInjection Moulding of Test Specimens of Thermoplastic Materials; 294-1: Part 1General Principles and Multipurpose Test Specimens (ISO Type A Mould) and Bars (ISO Type B Mould); ISO 294-2: Part 2Small Tensile Bars (ISO Type C Mould); ISO 294-3: Part 3Plates (ISO Type D Moulds).

Keywords:
injection-molding; mold design; test specimen preparation; thermoplastics; Acetal plastics; Injection molding/extrusion compounds; Molding/extrusion compounds/materials; PET (poly(ethylene terephthalate)); PMMA (poly(methyl methacrylate)); Polyalkylene terephthalates; Polyamide (PA); Polycarbonate (PC); Polypropylene (PP); Reciprocating screw injection molding machines; Thermoplastic elastomers (TPE); Thermoplastics
50,13
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta