Saltar navegación principal
Normas ASTM – AENOR
ASTM D4048-10

ASTM D4048-10

Standard Test Method for Detection of Copper Corrosion from Lubricating Grease

Fecha:
2017-01-18 /Historical
Superseeded by:
Significance and Use:

This test method measures the tendency of lubricating grease to corrode copper under specific static conditions. It may be of some value in predicting possible chemical attack on lubricated parts, such as bearings that contain copper or copper alloys. Such corrosion, for example, can cause premature bearing failures. However, no correlations with actual field service, most of which are under dynamic conditions, have been established. It does not measure either the ability of the lubricant to inhibit copper corrosion caused by factors other than the lubricant itself nor does it measure the stability of the grease in the presence of copper.

Scope:

1.1 This test method covers the detection of the corrosiveness to copper of lubricating grease.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and heal practices and determine the applicability of regulatory limitations prior to use.For specific warning statements, see Sections 7, 8, and 10.

Keywords:
copper corrosion; copper strip; copper tarnish; lubricating grease; Copper corrosion; Copper strip tarnish; Corrosion--petroleum products; Lubricating grease
43,95
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta