Saltar navegación principal
ASTM E775-87(2008)e1

ASTM E775-87(2008)e1

Standard Test Methods for Total Sulfur in the Analysis Sample of Refuse-Derived Fuel

2015-09-14 /Historical
Superseeded by:
Significance and Use:

The standards are available to producers and users of RDF for determining the total sulfur content of the fuel.


1.1 These test methods cover two alternative procedures for the determination of total sulfur in prepared analysis samples of solid forms of refuse-derived fuel (RDF). Sulfur is included in the ultimate analysis of RDF.

1.2 The test methods appear in the following order:

Test Sections
Eschka Method8-11
Bomb Washing Method12 and 13

1.3 These test methods may be applicable to any waste material from which a laboratory analysis sample can be prepared.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see Section 6.

Bomb washing method; Eschka method; Refuse-derived fuel (RDF); Sulfur
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta