Saltar navegación principal
Normas ASTM – AENOR
ASTM D4325-08

ASTM D4325-08

Standard Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes

Fecha:
2013-12-11 /Historical
Superseeded by:
Significance and Use:

The physical and electrical properties, including break strength, elongation, dielectric strength, dissipation factor, permittivity, fusion, etc., will vary with temperature and moisture content. Control the temperature and moisture content of the sample for these test methods to yield consistent and reproducible results.

Scope:

1.1 These test methods cover the methods and procedures for testing electrically insulating and semi-nonmetallic conducting rubber tapes designed for splicing, terminating, and sheath repair of electrical wire and cable.

1.2 The test methods appear in the following sections:

Section
Referenced Documents2
Conditioning5-6
Dielectric Strength35-40
Dimensions11-16
Dissipation Factor22-26
Elongation17-21
Heat Exposure46-49
Fusion7-10
Ozone Resistance41-45
Permittivity22-26
Sample Requirements4
Tensile Strength17-21
Volume Resistivity27-34
Ultraviolet and Weather Resistance50-54

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

Note 1—There is no IEC equivalent to these methods.

1.4 Unless otherwise stated, measurements are made on tapes from which the removable separator has been removed.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precaution statements see 43.1.

1.6 This is a fire-test response standard.

Keywords:
dielectric strength; dissipation factor; elongation; fusion; heat exposure; ozone resistance; permittivity; rubber electrical insulating tape; rubber semi-conducting nonmetallic tape; tensile strength; ultraviolet and weather exposure; volume resistivity; Conditioning--electrical insulating materials; Conductance and conductivity (electrical)--insulating materials; Dielectric breakdown voltage; Dimensions; Electrical insulating rubber; Electrical insulating tape; Permittivity (dielectric constant)--electrical insulating materials; Semi-conducting materials; Sheath repair; Splices/splicing; Tensile properties/testing--electrical insulating materials; Terminating; Thickness--electrical insulating materials; Ultraviolet (UV) analysis--rubber; Volume resistivity; Weathering; Width; Electrical resistance/resistivity--insulating materials; Elongation--electrical insulating materials; Fusion; Heating tests--electrical insulating materials; Heat resistance; Insulating tape; Length; Micrometer measurement; Nonmetallic materials; Ozone (O<inf>3</inf>) resistance
51,73
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta