Saltar navegación principal
Normas ASTM – AENOR
ASTM D3618-05

ASTM D3618-05

Standard Test Method for Detection of Lead in Paint and Dried Paint Films

Fecha:
2010-12-31 /Historical
Superseeded by:
Significance and Use:

The permissible level of heavy metals in certain coatings is specified by governmental regulatory agencies. This test method provides a fully documented procedure for determining low concentrations of lead present in both water and solvent-reducible coatings to determine compliance.

Scope:

1.1 This test method is intended as a screening test to determine if the solids in a paint contain more than 0.5 % lead. The test described barely detects the presence of 0.4 % but gives a definite positive result at the 0.5 % level. Note 1This test method may be used to detect the presence of lead at concentrations higher or lower than 0.5 % by making appropriate changes in the specimen size and reagent quantities specified.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 Paints giving an unexpected positive or questionable result should be analyzed quantitatively for lead, using Test Method D 3335.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section .

Keywords:
lead; lead in paints and dry paint films; spat test for lead
45,11
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta