Saltar navegación principal
Normas ASTM – AENOR
ASTM D619-99(2004)

ASTM D619-99(2004)

Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation (Withdrawn 2013)

Fecha:
2013-01-01 /Historical
Superseeded by:
Abstract:

These test methods details the standard procedures for testing certain properties of vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation. Arc resistance, ash content, bond strength (ply adhesion), bursting strength, compressive strength, conditioning, density, dielectric strength, dimensional measurements, flammability, flexural strength, silica content, tearing strength, tensile strength, thickness (for sheets), resistance to impact, Rockwell hardness, volatile matter content, water absorption, and zinc chloride content are among the properties that these test methods shall be able to examine.

Scope:

1.1 These test methods cover the procedures for testing vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation.

1.2 The procedures appear in the following sections:

ProcedureSectionArc resistanceAshBond strength (ply adhesion)Bursting strengthCompressive strength, , ConditioningDensity, , Dielectric strength, Dimensional measurements, FlammabilityFlexural strength, SilicaTearing strengthTensile strength, , Thickness (sheets)Resistance to impactRockwell hardnessVolatile matterWater absorptionZinc chloride

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in and .

Note 1

The test methods described herein are similar technically to those described in IEC Publication 60667-2. Not all of the tests in this document are included in IEC 60667-2, and the procedures in the two publications are not completely identical; but it is expected that comparable results will be obtained from most of the procedures and comparative tests should be made if necessary before directly comparing results of tests using the different procedures.

Keywords:
arc resistance; ash content; bond strength; bursting strength; compressive strength; density; dielectric strength; flame resistance; flexural strength; impact resistance; inside diameter; outside diameter; ply adhesion; rigid rods; rigid sheets; rigid tubes; Rockwell hardness; silica content; tear resistance (internal); tensile strength; thickness; volatile content; vulcanized fibre; wall thickness; water absorption; zinc chloride content
51,24
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta