Saltar navegación principal
Normas ASTM – AENOR
ASTM F690-86(2003)e2

ASTM F690-86(2003)e2

Standard Practice for Underground Installation of Thermoplastic Pressure Piping Irrigation Systems (Withdrawn 2012)

Fecha:
2012-11-01 /Withdrawn
No replacement
Scope:

1.1 This practice covers general and basic procedures related to the proper installation of thermoplastic, flexible, pressure piping, 36 in. nominal size and smaller, for underground irrigation systems. Because there is considerable variability in end-use requirements, soil conditions, and thermoplastic piping characteristics, it is the intent of this practice to outline general objectives and basics of proper installation and to provide pertinent references, rather than to prescribe detailed installation procedures.

1.2 This practice should not be used for installing thermoplastic underground sewer, drain, potable water, conduit or gas service piping.

1.3 The values stated in inch-pound units are to be regarded as the standard. Values in parentheses are given for information only.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords:
drainage systems-land drainage; underground installation of thermoplastic pressure piping irrigation; systems, practice; installation-underground; thermoplastic pressure piping irrigation systems, practice
50,76
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta