Saltar navegación principal
Normas ASTM – AENOR
ASTM A985-01a

ASTM A985-01a

Standard Specification for Steel Investment Castings General Requirements, for Pressure-Containing Parts

Fecha:
2017-08-16 /Historical
Superseeded by:
Scope:

1.1 This specification covers a group of common requirements, which are mandatory for steel castings produced by the investment casting process for pressure-containing parts under each of the following ASTM Specifications:

Title of SpecificationASTM Designation
Steel Castings, Carbon, Suitable for Fusion Welding A 216/A 216M
for High-Temperature Service
Steel Castings, Martensitic Stainless and Alloy, for A 217/A 217M
Pressure-Containing Parts Suitable for High-
Temperature Service
Castings, Austenitic, Austenitic-Ferritic (Duplex), A 351/A 351M
for Pressure-Containing Parts
Steel Castings, Ferritic and Martensitic, for Pressure- A 352/A 352M
Containing Parts Suitable for Low-Temperature
Service
Steel Castings, Alloy, Specially Heat-Treated, for A 389/A 389M
Pressure-Containing Parts, Suitable for High-
Temperature Service
Steel Castings Suitable for Pressure Service A 487/A 487M

1.2 This specification also covers a group of supplementary requirements, which may be applied to the above specifications as indicated therein. These requirements are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.

1.3 When investment casting are ordered, the requirements of this specification shall take precedence over the individual material specification requirements.

1.4 The values stated in either inch-pound or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in parentheses. The values in each system are not exact equivalent; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification. Inch-pound units are applicable for material ordered to Specification A 985 and SI units for material ordered to Specification A 985M.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords:
casting; investment casting; master heat; pressure containing; steel casting; subheat
57,98
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta