Saltar navegación principal
Normas ASTM – AENOR
ASTM G110-92(1997)

ASTM G110-92(1997)

Standard Practice for Evaluating Intergranular Corrosion Resistance of Heat Treatable Aluminum Alloys by Immersion in Sodium Chloride + Hydrogen Peroxide Solution

Fecha:
2017-08-16 /Historical
Superseeded by:
Scope:

1.1 This practice covers the procedures for immersion tests in sodium chloride + hydrogen peroxide solution. It is primarily for tests of wrought heat treatable aluminum alloys (2XXX and 7XXX) but may be used for other aluminum alloys, including castings. It sets forth the specimen preparation procedures and the environmental conditions of the test and the means for controlling them.

1.2 This practice is intended for evaluations during alloy development and for evaluating production where it may serve as a control test on the quality of successive lots of the same material (see MIL-H-6088 and U.S. Federal Test Method Std. 151b). Therefore strict test conditions are stipulated for maximum assurance that variations in results are attributable to lot-to-lot differences in the material being tested.

Note 1-This practice does not address sampling or interpretation or significance of results.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords:
Aluminum alloys; Corrosion-Al/Al alloys; Corrosion-intergranular; Heat-treatable aluminum alloys; Hydrogen peroxide; Immersion; Intercrystalline corrosion; Sodium chloride; intergranular corrosion resistance-wrought heat-treatable aluminum
44,46
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta