Saltar navegación principal
Normas ASTM – AENOR
ASTM F97-72(1997)e1

ASTM F97-72(1997)e1

Standard Practices for Determining Hermeticity of Electron Devices by Dye Penetration

Fecha:
2017-08-16 /Historical
Superseeded by:
Scope:

1.1 These practices cover procedures that will normally detect and locate the sites of gross leaks in electron devices.

1.2 These procedures are suitable for use on selected parts during receiving inspection or to verify and locate leakage sites for production control. They are not quantitative; no indication of leak size can be inferred from the test.

1.3 These procedures are most suitable for use on transparent glass-encased devices; all methods are applicable to transparent parts with an internal cavity. Method A, Penetrant-Capillary, is also applicable to parts, such as terminals, end seals or base assemblies, without an internal cavity, and Method C, Penetrant-Pressure Followed by Vacuum, can be used on opaque parts with an internal cavity. Method B, Penetrant-Pressure, can also be used on opaque parts with an internal cavity if the part is opened after dye penetration and before inspection. Parts that have an internal cavity may either contain gas (such as air, nitrogen, nitrogen-helium mixture, etc.) or be evacuated. These procedures are not suitable for use on grease-filled components.

1.4 Because of the possibility of dye entrapment between the component and an attached part, components with mechanically attached parts, such as a radiator on a power transistor, should be tested before the attachment is made or after it has been removed.

Note 1-Alternative methods for determining hermeticity of electron devices may be found in Practices F98 (see 2.1) and Test Methods F134 (see 2.1).

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statement, see Section 8.

Keywords:
Contamination-semiconductors; hermeticity determination, by dye penetration, practice,; Dye technique; hermiticity of electron devices, practice,; Electron tubes-hermeticity; Hermeticity-electron devices; dye penetration, practice,; Leak testing-electron devices; hermeticity, by dye penetration, practice,; Penetrant dye technique; hermeticity of electron devices, practice
45,39
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta