Saltar navegación principal
Normas ASTM – AENOR
ASTM E949-88(1996)

ASTM E949-88(1996)

Standard Test Method for Total Moisture in a Refuse-Derived Fuel Laboratory Sample

Fecha:
2010-12-31 /Historical
Superseeded by:
Scope:

1.1 This test method covers the measurement of the total moisture in RDF as it exists at the time it is sampled. Because of its empirical nature, strict adherence to test procedures are required for valid results. The standard is available to producers, vendors, and consumers as a total, two-stage moisture method.

1.2 Since RDF can vary from extremely wet (water saturated) to relatively dry, special emphasis must be placed on sampling, sample preparation, and the method of determination.

1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For hazard statement, see Section 7.

Keywords:
Moisture analysis-refuse-derived fuel/RDF; Sampling-refuse-derived fuel/RDF; total moisture in a refuse-derived fuel/RDF sample, test,; Resource recovery-solid waste refuse-derived fuel/RDF; total moisture in a refuse-derived fuel sample, test
44,62
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta