Saltar navegación principal
Normas ASTM – AENOR
ASTM D5635-98

ASTM D5635-98

Standard Test Method for Dynamic Puncture Resistance of Roofing Membrane Specimens

Fecha:
2010-12-31 /Historical
Superseeded by:
Scope:

1.1 This test method covers the evaluation of the maximum dynamic puncture load that roofing membrane samples can withstand, without allowing the passage of water, when subjected to impact from a rigid object having a sharp edge.

1.2 This laboratory test can be conducted at any desired temperature using membrane samples manufactured in a factory or prepared in a laboratory.

1.3 Roof membrane specimens to which the method is applicable include bituminous built-up, polymer-modified bitumens, vulcanized rubbers, non-vulcanized polymeric, and thermoplastic materials.

1.4 This test method is not applicable to aggregate-surfaced membrane specimens; however, it is applicable to specimens having factory-applied granules.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords:
Dynamic puncture resistance; Impact energy; Insulation substrate; Maximum dynamic puncture load; Membranes; Nonvulcanized polymeric membrane; Performance-roofing materials; Polymer-modified bitumens; Puncture resistance; Roofing and waterproofing materials; Roofing and waterproofing materials-bituminous; Roofing and waterproofing materials-plastic; Roofing and waterproofing materials-rubber; Roofing membranes-built-up roofs; Thermoplastic materials (for roofing/waterproofing); Vulcanized rubbers; dynamic puncture resistance-roofing membrane specimens, test
44,44
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta