Saltar navegación principal
Normas ASTM – AENOR
ASTM D3233-93(1998)

ASTM D3233-93(1998)

Standard Test Methods for Measurement of Extreme Pressure Properties of Fluid Lubricants (Falex Pin and Vee Block Methods)

Fecha:
2017-08-16 /Historical
Superseeded by:
Scope:

1.1 These test methods cover two procedures for making a preliminary evaluation of the load-carrying properties of fluid lubricants by means of the Falex Pin and Vee Block Test Machine.

Note 1-Additional information can be found in Appendix X1 regarding coefficient of friction, load gage conversions, and load gage cablibration curve.

1.2 The values stated in SI units are to be regarded as standard. Because the equipment used in these test methods is available only in inch-pound units, the SI units are omitted when referring to the equipment and the test specimens.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords:
Extreme-pressure properties-lubricating fluids; Falex method; Load-carrying lubricants; Lubricants (fluid)-extreme pressure properties; Pin and vee; Pressure testing-petroleum products; Vee Block method; Wear testing-petroleum products; extreme pressure properties-fluid lubricants, by Falex pin and vee block; methods, test
50,61
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta