Saltar navegación principal
Normas ASTM – AENOR
ASTM D1894-01

ASTM D1894-01

Standard Test Method for Static and Kinetic Coefficients of Friction of Plastic Film and Sheeting

Fecha:
2017-08-16 /Historical
Superseeded by:
Scope:

1.1 This test method covers determination of the coefficients of starting and sliding friction of plastic film and sheeting when sliding over itself or other substances at specified test conditions. The procedure permits the use of a stationary sled with a moving plane, or a moving sled with a stationary plane. Both procedures yield the same coefficients of friction values for a given sample.

Note 1--For the frictional characteristics of plastic films partially wrapped around a cylinder, or capstan, see Test Method G143 under the jurisdiction of ASTM Subcommittee G02.50.

1.2 Test data obtained by this test method is relevant and appropriate for use in engineering design.

1.2.1 As an option to this test, coefficient of friction may be run at temperatures other than 23C by heating only the plane while the sled is at ambient temperature.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Note 7.

Note 2--This test method and ISO/DIS 8295-1994 are not technically equivalent.

Keywords:
friction; kinetic coefficient of friction; plastic film; plastic sheeting; slip; static coefficient of friction
51,8
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta