Saltar navegación principal
Normas ASTM – AENOR
ASTM D1179-99

ASTM D1179-99

Standard Test Methods for Fluoride Ion in Water

Fecha:
2017-08-16 /Historical
Superseeded by:
Scope:

1.1 These test methods cover the determination of fluoride ion in water. The following two test methods are given:

Sections Test Method A (Distillation) 7 to 14 Test Method B (Ion Selective Electrode) 15 to 22

1.2 Test Method A covers the accurate measurement of total fluoride in water through isolation of the fluoride by distillation and subsequent measurement in the distillate by use of the ion selective electrode method. The procedure covers the range from 0.1 to 2.6 mg/L of fluoride.

1.3 Test Method B covers the accurate measurement of simple fluoride ion in water by means of an ion selective electrode. With this test method, distillation is eliminated because the electrode is not affected by the interferences common to colorimetric procedures. Concentrations of fluoride from 0.1 to 1000 mg/L may be measured.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see 12.1.2.

1.5 Former Test Method A, SPADNS Photometric Procedure, was discontinued. Refer to Appendix X1 for historical information.

Keywords:
Distillation; Fluoride content; Fluoride (ion) content; Ion-specific electrode; SPADNS procedure; Water-inorganic constituents; fluoride ion-water, by distillation/ion selective electrode method,; test
50,72
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta