Saltar navegación principal
ASTM A530/A530M-18

ASTM A530/A530M-18

Standard Specification for General Requirements for Specialized Carbon and Alloy Steel Pipe

2020-01-29 /Active

This specification covers a general requirements for specialized carbon and alloy steel pipe. Tensile tests, tension tests, flattening tests, hydrostatic tests and ultrasonic tests shall be made to conform to the requirements specified. If the mechanical results do not conform to the requirements specified, retests shall be made. Defects in seamless pipe shall be repaired by welding.


1.1 This specification2 covers a group of requirements which, with the exceptions of Section 6.3, Section 14, Section 21, and Section 22, are mandatory requirements to the ASTM pipe product specifications noted below unless the product specification specifies different requirements, in which case the requirement of the product specification shall prevail.

1.2 Sections 6.3 or 21 are mandatory if the product specification has a requirement for product analysis or flattening tests.

1.3 Section 22 is mandatory if the product specification has a hydrostatic test requirement without defining the test parameters.

1.4 Section 14 is for information only.

1.5 In case of conflict between a requirement of the product specification and a requirement of this general requirement specification, only the requirement of the product specification need be satisfied.

Title of Specification

ASTM DesignationA

Seamless Carbon Steel Pipe for High-Temperature Service


Metal-Arc-Welded Steel Pipe for Use With High-Pressure
    Transmission Systems


Seamless Carbon Steel Pipe for Atmospheric and Lower


Centrifugally Cast Carbon Steel Pipe for High-Temperature


Electric-Fusion-Welded Steel Pipe for Atmospheric and
    Lower Temperatures


Electric-Fusion-Welded Steel Pipe for High-Pressure Service
    at Moderate Temperatures


Carbon and Alloy Steel Pipe, Electric-Fusion-Welded for
    High-Pressure Service at High Temperatures


1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the “M” designation (SI) of the product specification is specified in the order.

Note 1: The dimensionless designator NPS (nominal pipe size) has been substituted in this standard for such traditional terms as “nominal diameter,” “size,” and “nominal size.”

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

alloy steel pipe; carbon steel pipe; general delivery requirements; steel pipe;
Idioma Formato

Formato físico y digital

Nota: Precios sin IVA ni gastos de envío

Añadir a la cesta